Motorola WS2000 - Wireless Switch - Network Management Device System Reference Manual page 302

Wireless switch
Hide thumbs Also See for WS2000 - Wireless Switch - Network Management Device:
Table of Contents

Advertisement

13-28 WS2000 Wireless Switch System Reference Guide
reg
rts
short-pre
802.1x
mac
ap_scan
radio_
type
ap_type
sip_cac_
mode
allowed_
sip_session
legacy_
mode
mu-power-
adjustment
asset-name
<idx>
<indoor>
<idx>
<bytes>
/
<idx>
enable
disable
<username> <password>
<idx>
<mac>
<idx>
<mode>
<idx>
<radio_
type>
<idx>
<radio_
type>
/
enable
disable
<idx>
<sip_
session>
/
enable
disable
<ap-index> <adjvalue>
<idx>
<asset-
name>
Sets Access Port <idx> regulatory
<ch> <pwr>
parameters, which <indoor> is one of
; <ch> is the channel to use, and
in/out
<pwr> is the power (in dB from 4 to 20).
Select the value of <ch> from the
appropriate list.
802.11b ch -- 1 to 14
802.11a ch --
36,40,44,48,52,56,60,64,149,153,157,161
Note: Regulatory parameter values depend on
country of operation and radio type. Refer to
documentation for regulatory information.
Sets the RTS threshold for Access Port
<idx> to <bytes> (e.g., 2341).
Enables or disables the short preamble
mode for Access Port <idx>.
Sets the 802.1x username and password on
AP 300 Access Ports. Both parameters can
be up to 64 characters long.
Sets the MAC address of AP <idx> to <mac>
(MAC address format is
XX:XX:XX:XX:XX:XX)
Sets the scan mode for Rogue AP detection
where <idx> is the access port index (1-12)
and mode is one of
on-chan, full-detector
Sets the Radio Type of an access port where
<idx> is the access port index (1-12) and
<radio_type> is one of
802.11b,
802.11b/g
Sets the AP type of an Access Port <idx> to
AP type. AP type is one of
AP300
Enables or disables SIP Call Admission
Control.
Sets the allowed number of SIP sessions for
this portal. The value for <sip_session> lies
between 1 and 100.
Enables or disables legacy mode support for
AP300s.
Sets Symbol MUs operating power in dBm.
<ap-index> is the index of the Symbol AP
and <adjvalue> is the MU power adjustment
value in dBm (valid 0-20)
Sets asset name for the Access Port with
<idx> (1-12) with <asset-name> (1-50
characters)
in
none, detector,
.
802.11a,
.
AP100, AP200,
or

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents