Motorola WS2000 - Wireless Switch - Network Management Device System Reference Manual page 63

4. If the NAT type is 1 to Many, the
allowing the administrator to specify address assignments for each subnet. If no translation should be
done, none should be selected for the subnet.
5. Click the Port Forwarding
traffic from the associated WAN IP address. When finished, click the
6. Click Add to add a new port forwarding entry and fill in the following fields.
Name Enter a name for the service that is being forwarded. The name can be any alphanu-
meric string and is used for easy identification of the service.
Transport Use this pull-down menu to specify the transport protocol used in this service. The
choices are ALL, TCP, UDP, ICMP, AH, ESP, and GRE.
Start Port / Enter the port or ports used by this service. To specify a single port, enter the port num-
End Port ber in the
Port fields to enter the port numbers. For example, enter 110 in the
115 in the
IP Address Enter the
within the specified NAT range for the associated WAN IP address.
1 to Many button in the adjacent
button to display a sub-screen of port forwarding parameters for inbound
Start Port field. To specify a range of ports, use both the
End Port field.
IP address to which the specified service is forwarded. This address must be
WAN Configuration
Outbound Mappings field is active,
Ok button to close the screen.
Start Port
Start Port
4-9
and End
field and