Setting Up Dhcp Options For Firmware Upload - Motorola WS2000 - Wireless Switch - Network Management Device System Reference Manual

2. Verify that the Compact Flash card is firmly seated in the WS2000's Compact Flash slot.
3. Click the Format CF
4. Click Yes to continue formatting the card.

7.7.4 Setting Up DHCP Options for Firmware Upload

It is also possible to configure the switch to receive firmware and configuration files automatically from a
server using the Dynamic Host Configuration Protocol (DHCP). This features allows quick and automatic
rollouts of new configurations or firmware updates across the network without manually updating each
switch.
Select [System Configuration]
switch to accept DHCL downloads.
7.7.4.1 Setting Up the Switch
1. Check Enable Automatic Firmware Update
receive firmware updates from a server using the DHCP protocol. By default this option is disabled.
2. Check Enable Automatic Configuration Update
configuration file updates from a server using DHCP. By default this option is disabled.
3. Set the Auto Upgrade Interval
4. Use the Interface
received. This interface can be either the WAN port or any of the configured subnets on the switch. By
default this value is set to WAN.
5. Optional: If you wish to change or specify a
DHCP Vendor class ID
upgrade parameters. The external DHCP server which handles the DHCP client needs to be configured
with this option to provide TFTP/FTP server IP, firmware file name and config file to facilitate WS2000 for
button.
--> [Cfg/Firmware Mgt]
(in seconds) for the WS2000 to check the server for automatic updates.
menu to select the interface from which Firmware and Configuration updates will be
DHCP Vendor Class Id
is used by the onboard DHCP clients as a unique identifier for Firmware/Config
--> DHCP Options (Sys Update)
to allow the WS 2000 Wireless Switch to automatically
to allow the WS 2000 to automatically receive
enter it here.
7-9
Switch Administration
to configure the