Ws2000>Admin(System.redundancy)> Set - Motorola WS2000 - Wireless Switch - Network Management Device System Reference Manual

WS2000>admin(system.redundancy)> set
Description:
Sets the parameters for redundant switch mode.
Syntax:
set mode
op-state
heartbeat
revertdelay
hb_interfac
e
Example:
admin(system.redundancy)>
can not set the value when the op_state is either upgrade or standalone
admin(system.redundancy)>
admin(system.redundancy)>
admin(system.redundancy)>
Related Commands:
show Displays the redundancy settings.
/ Tells the switch that it is either the
primary
switch when redundancy is enabled. This parameter can only be set if
standby
the
op-state
/ Sets the redundancy operation state of the switch to one of:
upgrade
standalon
•
standalone
/
e
independently of any other WS 2000 switches on the network. This is the
redundanc
default setting.
y
•
redundancy
primary and the other as a standby.
• —The primary and standby switches must run the same version of
upgrade
the switch firmware for redundancy to work correctly. If the firmware on only
one of the switches is updated, redundancy is disabled and the Operational
State is automatically set to Upgrade.
Sets the heartbeat interval for the switch to <interval> (
<interval
>
Specifies the amount of time (
<delay>
heartbeat packet before the secondary (standby) switch will take over.
Indicates which port on the switch (
<port>
the port that contains the Ethernet cable that attaches the two switches.
set mode standby
set op-state redundancy
set mode standby
Command Line Interface Reference
primary
parameter is set to
redundancy
—The switch has no redundancy capabilities and operates
—Two WS 2000 switches are connected, with one set as a
– minutes) after not receiving a
1 20
– ) is the heart beat port. This is
1 6
13-313
or (standby)
secondary
.
– ) seconds.
1 60