Port Configuration - Motorola WS2000 - Wireless Switch - Network Management Device System Reference Manual

Transport Description
RAW_IP RAW IP is used when communication is done directly to the IP layer without using any additional
protocols.
4. Select a Port from the pulldown menu for this IP Filtering rule to apply to. The default is
the filtering to all ports on the switch.
5. Enter the source IP range for the filtering rule in the
6. Enter the destination IP range for the filtering rule in the
7. The In Use field will display the current state of the filtering rule. When the rule is in use it will read
YES. When the rule is not in use this field will read NO.

3.8 Port Configuration

Use the

Port Configuration

screen to set their Auto Negotiation mode, speed and duplex states too.
When the Auto Negotiation
states for each port. To disable this, select
To select the operating speed for the port, select either
each port. This value should be selected based on your network configuration.
To select the duplex mode for a port, select either
mode, traffic can pass only in one direction at a time. It can be either Rx or Tx. In full-duplex mode, traffic
can pass in both direction simultaneously.
screen to enable or disable each of the 6 LAN ports and the WAN port. Use this
is enabled, the WS2000 determines the best operating speed and the duplex
Disable from the Auto Negotiation drop-down list.
Half or
LAN/Subnet Configuration
Src Start and Src End fields.
Dst Start and Dst End
10 M or 100M from the Speed
Full from the Duplex drop-down list. In half-duplex
3-17
All and will apply
fields.
drop-down list for