Enabling Ppp Authentication For All Demand Interfaces; Configuring Pap Authentication For A Demand Interface; Configuring Chap Authentication For A Demand Interface - HP 7102dl - ProCurve Secure Router Configuration Manual

Configuring Backup WAN Connections
Configuring Demand Routing for Backup Connections

Enabling PPP Authentication for All Demand Interfaces

You must configure the PPP authentication protocol that the router uses for
inbound calls. To configure the authentication protocol that the demand
interfaces expect to receive for inbound calls, enter the following command
from the global configuration mode context:
Syntax: data-call authentication protocol [chap | pap]
Include either the chap option or the pap option, depending on which PPP
authentication protocol you want to use.
You should also specify which authentication protocol the demand interfaces
send to authenticate themselves to a peer when answering a call. From the
global configuration mode context, enter:
ProCurve(config)# data-call sent authentication protocol [chap | pap]
By default no authentication protocol is specified for demand interfaces.
Disabling the Authentication Protocol. To disable the global setting for
the PPP authentication protocol that is used for demand routing interfaces,
enter:
ProCurve(config)# no data-call authentication protocol
ProCurve(config)# no data-call sent authentication protocol

Configuring PAP Authentication for a Demand Interface

If you want to use PAP, you must configure the username and password that
the ProCurve Secure Router sends when the far-end router requests authen-
tication information for a dial-up interface. From the demand interface con-
figuration mode context, enter:
Syntax: ppp pap sent-username <username> password <password>

Configuring CHAP Authentication for a Demand Interface

If you want to use CHAP, you must configure the password that the ProCurve
Secure Router sends when the far-end router requests authentication infor-
mation for a dial-up interface. From the demand interface configuration mode
context, enter:
Syntax: ppp chap password <password>
3-45