Using The Firewall Wizard - HP 7102dl - ProCurve Secure Router Configuration Manual

N o t e
Using the Web Browser Interface for Advanced Configuration Tasks
f. You can delete timeout policies that have already been added. These
policies are listed below the Add/Modify button in the Delete Entries
section. Click the Delete button to the right of the specific policy
timeout.

Using the Firewall Wizard

The firewall wizard helps you to quickly configure NAT on a router that
connects to the Internet. The firewall wizard enables the router to:
perform many-to-one NAT on all traffic outbound to the Internet
perform port forwarding to allow external traffic to internal servers
drop all other external traffic
The firewall wizard overwrites policies applied to both the private and public
interface. You should therefore use the firewall wizard before configuring
other security policies. You can then customize policies as described in
"Configuring Access Control from the Web Browser Interface" on page 16-41.
To use the firewall wizard to configure NAT:
1. Select Firewall Wizard under Firewall in the left navigation bar. The
wizard will display in a new window.
2. The wizard warns you that it will overwrite previous configurations. Click
Next. The router must have at least two IP interfaces (a private and a
public) for the firewall wizard to proceed.
3. Select the interface that connects to the Internet from the Interface pull-
down menu.
4. If Internet users do not need to access any servers internal to your
network, move to step 9.
Configuring the ProCurve Secure Router OS Firewall
16-37