HP 7102dl - ProCurve Secure Router Configuration Manual page 190

Configuring Backup WAN Connections
Quick Start
3-102
Replace <value> with the number of times between 1 and 65535 that
the demand interface should attempt the call. (Enter 0 to have the
demand interface make an unlimited number of attempts.)
Table 3-20. Defining a Resource Type for Connection Instructions
Option Description
isdn-64k Any dial resource can be used, but if ISDN is used, the call must be placed
using 64 KB.
isdn-56k Any dial resource can be used, but if ISDN is used, the call must be placed
using 56 KB.
forced-analog Only analog resources can be used.
forced-isdn-64k Only ISDN resources can be used, and the call must be placed using
64 KB.
forced-isdn-56k Only ISDN resources can be used, and the call must be placed using
56 KB.
f. The idle timer determines the length of time the backup connection
can be idle before the demand interface terminates it. If so desired,
you can set the timer to match the billing increments for your backup
connection. Enter this command from the demand interface configu-
ration mode context:
Syntax: idle-timeout <1-2147483>
4. Configure the BRI interface.
a. To access the BRI interface configuration mode context, enter:
Syntax: interface bri <slot>/<port>
For example, you might enter:
ProCurve(config)# interface bri 1/2
b. Set the ISDN signaling (switch) type if your service provider is not
using the default setting for the ISDN module your are using. For the
ISDN BRI U module, the default setting is isdn switch-type basic-
5ess. For the ISDN BRI S/T modules, the default setting is isdn
switch-type basic-net3. If your service provider is using a different
ISDN signaling (switch) type, enter:
Syntax: isdn switch-type [basic-5ess | basic-ni | basic-dms | basic-net3]