HP 7102dl - ProCurve Secure Router Configuration Manual page 142

Configuring Backup WAN Connections
Configuring a Persistent Backup Connection
3-54
Optionally, you can:
replace incoming caller ID with a set number
use the modem for console dial-in
Setting the Country. Depending on where the router is located, the analog
backup module may need to use different signals to connect to the PSTN or
PTT. You must identify the country for the analog module from the global
configuration mode context:
Syntax: modem countrycode <country>
For example, if the router is in Munich, Germany, enter:
ProCurve(config)# modem countrycode Germany
Enter modem countrycode ? for a complete list of keywords for countries.
The default setting is USA and Canada.
For the rest of the configuration commands, you must access the modem
configuration mode context.
Activating the Interface. The modem interface must be manually acti-
vated. First, access the modem interface:
Syntax: interface modem <slot>/<port>
For example, you might enter:
ProCurve(config)# interface modem 1/2
The slot refers to the slot number for the module on top of which you installed
the backup module. The port is the port number for the backup interface on
this dl module.
Activate the interface by entering:
Syntax: no shutdown
You can check the status of the interface by entering:
ProCurve(config-modem 1/2)# do show int mod 1/2
The status should be "UP" and "on-hook." Activating the backup interface does
not activate the actual backup connection; it only enables backup support.