Configuring Frame Relay Fragmentation And Rate Limiting - HP 7102dl - ProCurve Secure Router Configuration Manual

Using the Web Browser Interface for Advanced Configuration Tasks
Figure 16-57. Applying a QoS Policy to an Interface
8. Return to the QoS Map window. The Apply a QoS-policy to an Interface
window lists the name of all logical interfaces active on the router. The
display includes an Ethernet interface only if you have configured rate
limiting for it. Select the map name from the pull-down menu next to the
name of the interface that should mark packets.
9. Click Apply.
Configuring Frame Relay Fragmentation and Rate
Limiting
These instructions assume that you have already configured the Frame Relay
interface and PVCs. (See "Configure Frame Relay as the Data Link Layer
Protocol" on page 14-68 of the Basic Management and Configuration Guide.)
Follow these steps to configure fragmentation and rate limiting for a PVC:
1. Access the Frame Relay subinterface for the PVC for which you want to
limit the rate.
a. Click IP Interfaces under Router/Bridge in the navigation bar. Select
the Frame Relay subinterface.
b. If this interface does not have an IP address, then you must instead
select Physical Interfaces under System. Then choose the Frame
Relay interface associated with the PVC. You can then select the
subinterface from the Configured Permanent Virtual Circuits
window.
c. The Configuration window for the Frame Relay subinterface
displays.
2. The router fragments any packet larger than the fragmentation threshold.
Set the threshold in bytes in the Fragment field.
Configuring Quality of Service
16-73