Configuring One-To-One Nat - HP 7102dl - ProCurve Secure Router Configuration Manual

Using the Web Browser Interface for Advanced Configuration Tasks
Figure 16-40. Configuring Many-to-One NAT
2. Enter a policy descriptor, which will be displayed when you view the
running-config.
3. Configure which hosts you want to share the public IP address: all or a
specific subnet.
4. For Public IP Address, select an interface or enter a specific IP address.
5. Click Apply. The policy you created is now listed on the Configure
Policies for Security Zone window.

Configuring One-to-One NAT

1. To configure one-to-one NAT, use the pull-down menu to select 1:1 NAT
for the Policy Type in the Add New Policy window. Click Continue. The
Add New Policy to Security Zone window is displayed.
Configuring Access Control from the Web Browser Interface
16-51