HP 7102dl - ProCurve Secure Router Configuration Manual page 310

Configuring Network Address Translation
Configuring NAT
6-12
Table 6-3. Options for Specifying Source and Destination Addresses
Option
any
host <A.B.C.D>
hostname <hostname>
<A.B.C.D> <wildcard bits>
For example, if you want to select all the traffic destined for IP address
10.1.1.10, enter:
ProCurve(config-ext-nacl)# permit ip any host 10.1.1.10
If you select UDP or TCP as the protocol, you can also specify a source or
destination port (although you do not have to). For example, if you want to
configure one-to-one NAT for multiple devices, you should include a destina-
tion port as part of the criteria used to select traffic.
Table 6-4 shows the options you have for defining ports when you select UDP
or TCP as the protocol.
Table 6-4. Specifying Ports in Extended ACLs
Option
eq <port number>
gt <port number>
lt <port number>
range <first port number last port number> range of ports
neq <port number>
When you finish configuring the ACL, enter exit to return to the global
configuration mode context where you can configure the ACP.
Meaning
match all hosts
specify a single host or a single IP address
specify a single host by name rather than by IP address
specify a range of IP addresses
Explanation
specific port
all ports that are a larger number than the port
number you specify (not including the specified
port)
all ports that are a smaller number than the port
number you specify (not including the specified
port)
all ports except the port number you specify