Using the Web Browser Interface for Advanced Configuration Tasks
Configuring Quality of Service
16-72
Figure 16-56. Marking Packets with a ToS Value
4.
Move to the Packet Marking section. Enter the value with which the router
should mark packets:
a.
Select DSCP to enter a DiffServ value between 0 and 63.
b. Select Precedence to enter an IP precedence value between 0 and 7.
5.
Only set a maximum bandwidth if you want to place the marked traffic in
a low latency queue. See "Configuring LLQ" on page 16-67. If you want the
QoS map entry only to mark packets select Disable under Priority Queue
(see Figure 16-56).
6.
Click Apply.
7.
If necessary, repeat steps 2 through 6 to configure more map entries. For
each set of traffic to be marked on the same interface, give the entry the
same name but a different number. The router processes map entries in
order starting with the lowest. (You can also apply LLQ to the same
interface by configuring new map entries with the same name.)