HP 7102dl - ProCurve Secure Router Configuration Manual page 194

Configuring Backup WAN Connections
Quick Start
Required Configuration
Specify days that backup will not be
provided.
Specify time when backup support is
turned off.
Specify time when backup support is
turned back on.
Create a floating static route to the far-
end network.
3-106
Options
• • sunday
• monday
• tuesday
• wednesday
• thursday
• friday
• saturday
hh:mm:ss
For example, 18:30:00
hh:mm:ss
For example, 8:45:00
• • Obtain the destination network
address from the remote site
• Administrative distance should be
higher than that for the primary
route
1. Install the backup module. Refer to the "Installation Instructions" in the
ProCurve Secure Router dl ISDN BRI U Backup Module Quick Start
Guide.
2. Power up the router and move to the global configuration mode context.
Enter the BRI configuration mode context.
Syntax: interface bri <slot>/<port>
3. Enter the ISDN signaling type.
Syntax: isdn switch-type [basic-ni | basic-dms | basic-5ess]
For example:
ProCurve(config-bri 1/3)# isdn switch-type basic-ni
4. Enter the SPID and LDN.
Syntax: isdn spid1 <SPID1> <local site's LDN>
5. If you are using both B channels, you may need to enter a second SPID
and LDN.
Syntax: isdn spid2 <SPID2> <local site's LDN 2>
6. Activate the interface.
ProCurve(config-bri 1/3)# no shutdown
Your Setting