HP 7102dl - ProCurve Secure Router Configuration Manual page 410

Procurve secure router 7000dl series - advanced management and configuration guide

Hide thumbs Also See for 7102dl - ProCurve Secure Router:

Table of Contents

Setting Up Quality of Service

Configuring QoS for Ethernet

You would enter these commands to configure the QoS policy:

ProCurve(config)# ip access-list extended WebTraffic

ProCurve(config-ext-nacl)# permit tcp any host 192.168.1.20 eq www

ProCurve(config-ext-nacl)# exit

ProCurve(config)# ip access-list extended RemoteTraffic

ProCurve(config-ext-nacl)# permit ip 192.168.4.0 0.0.0.255 any

ProCurve(config)# qos map Outside 10

ProCurve(config-qos-map)# match ip rtp 16384 32764 all

ProCurve(config-qos-map)# priority 2000

ProCurve(config-qos-map)# qos map Outside 20

ProCurve(config-qos-map)# match list WebTraffic

ProCurve(config-qos-map)# bandwidth remaining percent 25

ProCurve(config-qos-map)# qos map Outside 30

ProCurve(config-qos-map)# match list RemoteTraffic

ProCurve(config-qos-map)# bandwidth remaining percent 25

ProCurve(config-qos-map)# interface eth 0/1

ProCurve(config-eth 0/1)# traffic-shape rate 8000000

ProCurve(config-eth 0/1)# qos-policy out Outside

Show Quick Links

Chapters

Table of Contents