HP 7102dl - ProCurve Secure Router Configuration Manual page 188

Configuring Backup WAN Connections
Quick Start
3-100
Replace <protocol> with one of the following:
– ahp
– esp
– gre
– icmp
– ip
– tcp
– udp
– number between 0 and 255
To specify the source and destination address, use the following:
Syntax: [any | host <A.B.C.D> |hostname <hostname> | <A.B.C.D> <wildcard
bits>]
For example, you might want to specify that the interesting traffic is
the IP traffic from any source to network 192.168.115.0 /24. You use
wildcard bits to specify a range of addresses. Enter:
ProCurve(config-ext-nacl)# permit ip any 192.168.115.0 0.0.0.255
c. After configuring the entries for the ACL, enter:
ProCurve(config-ext-nacl)# exit
3. Configure the demand interface.
a. Create the demand interface by entering:
ProCurve(config)# interface demand <number>
Replace <number> with a number between 1 and 1024 for this
demand interface. Each demand interface must have a unique
number.
b. Assign the demand interface an IP address.
Syntax: ip address <A.B.C.D> <subnet mask | /prefix length>
For example, you might enter:
ProCurve(config-demand 1)# ip address 10.10.10.1 255.255.255.252
Or
ProCurve(config-demand 1)# ip address 10.1.1.1 /30
c. Associate the ACL you created with the demand interface. From the
demand interface configuration mode context, enter:
Syntax: match-interesting [list | reverse list] <listname > [in | out]