HP 7102dl - ProCurve Secure Router Configuration Manual page 117

Replace <string> with the telephone number that the demand interface
should dial to make the connection.
Replace <resource-type> with one of the options listed in Table 3-4. The
option you enter will limit this connection to a particular type of dial-up
connection.
Table 3-4. Defining a Resource Type for Connection Instructions
Option Description
isdn-64k Any dial resource can be used, but if ISDN is used, the call must be placed
using 64 KB.
isdn-56k Any dial resource can be used, but if ISDN is used, the call must be placed
using 56 KB.
forced-analog Only analog resources can be used.
forced-isdn-64k Only ISDN resources can be used, and the call must be placed using
64 KB.
forced-isdn-56k Only ISDN resources can be used, and the call must be placed using 5
6 KB.
For example, if you are using ISDN backup, you should enter the forced-isdn-
64k or forced-isdn-56k options, depending on the speed of the B channel.
Your service provider should tell you which option to use.
Specifying the busyout-threshold <value> is optional. Include a value
between 1 and 65535 to specify the maximum number of times the ProCurve
Secure Router will try this connect sequence. If you specify 0, the ProCurve
Secure Router will make an unlimited number of attempts. If you specify any
other number, the ProCurve Secure Router will skip this connect sequence
after it reaches the maximum number. (Depending on your configuration, the
ProCurve Secure Router may cycle through the list of connect sequences more
than once in its attempt to establish a connection. For more information, see
"Configure the Number of Connect Sequence Attempts" on page 3-30.)
There is no default connect sequence. If you do not enter a connect-sequence
command, the demand interface will not be able to originate a backup
connection.
Deleting a Connect Sequence. To delete a connect sequence entry, enter:
ProCurve(config-demand 1)# no connect-sequence <sequence-number>
Configuring Backup WAN Connections
Configuring Demand Routing for Backup Connections
3-29