HP 7102dl - ProCurve Secure Router Configuration Manual page 491

Next configure a track:
7. Create the track and specify its name.
Syntax: track <name>
8. Specify the probe for the track.
• Specify one probe.
Syntax: test probe <name>
• Specify two probes, both of which must pass for the track to pass.
Syntax: test probe <name> and probe <name>
• Specify two probes, either of which can pass for the track to pass.
Syntax: test probe <name> or probe <name>
9. Optionally, specify a dampening interval.
Syntax: dampening-interval <seconds>
10. Configure the track's action.
• You can configure the track to remove a static route when the track
fails. This command is entered from the global configuration mode
context:
Syntax: ip route <destination network A.B.C.D> <subnet mask | /prefix
length> <next-hop A.B.C.D | forwarding interface ID> [<administrative dis-
tance>] track <name>
• You can configure the track to remove a DHCP default route when
the track fails. This command is entered from an interface configura-
tion mode context:
Syntax: ip address dhcp {client-id [ethernet 0/<port> |
HH:HH:HH:HH:HH:HH:HH] | hostname <hostname>} track <name>
[<administrative distance>]
Syntax: ip address dhcp [hostname <hostname> | no-domain-name | no-
nameservers] track <name> [<administrative distance>]
• You can configure the track to remove a negotiated default route when
the track fails. This command is entered from an interface configura-
tion mode context:
Syntax: ip address negotiated track <name> [<administrative distance>]
• You can enable the track to log changes in its state. This command is
entered from the network monitor track configuration mode context:
Syntax: log-changes
Network Monitoring
Quick Start
9-63