Quick Start - HP 7102dl - ProCurve Secure Router Configuration Manual

Network Monitoring

Quick Start

9-62
Quick Start
This section contains the commands that you must enter to quickly configure
network monitoring to control static and DHCP routes.
Only minimal explanation is provided. If you need additional information
about any of these options, check "Contents" on page 9-1 to locate the section
that contains the explanation you need.
First, configure probes to test a remote server or a connection to a remote
network:
1. Create the probe and select its type.
Syntax: probe <name> [icmp-echo | tcp-connect | http-request]
2. Specify the probe's destination.
• Specify an ICMP probe's destination:
Syntax: destination <hostname | A.B.C.D>
• Specify a TCP or HTTP probe's destination:
Syntax: destination <hostname | A.B.C.D> port <value>
3. Specify the probe's tolerance.
• Set the probe to fail after a certain number of consecutive failures:
Syntax: tolerance consecutive-failures <failures>
• Set the probe to fail after certain rate of failure (for example, 10 out
of 15):
Syntax: tolerance rate-of-failure <failures> <set size>
4. Specify the test's timeout or retain the default timeout (1.5 seconds for
ICMP probes and 10 seconds for TCP and HTTP probes).
Syntax: timeout <milliseconds>
5. Specify the probe's period or accept the default (60 seconds):
Syntax: period <seconds>
6. Optionally, repeat these steps to create another probe.