HP 7102dl - ProCurve Secure Router Configuration Manual page 966

Using the Web Browser Interface for Advanced Configuration Tasks
Configuring Access Control from the Web Browser Interface
N o t e
16-52
You must have more than one security zone configured on the router to use
one-to-one NAT. If you do not, the screen shown below includes an alert in the
Private Security Zone field.
Figure 16-41. Configuring One-to-One NAT
2. Enter a policy descriptor, which will be displayed when you view the
running-config.
3. For Public IP Address, use the pull-down menu to select Any or one of
the interfaces configured on the router. This setting determines the des-
tination addresses the router will match for this NAT policy.
4. For Private IP Address, enter the address the device is using on the
internal network.
5. From the Private Security Zone pull-down menu, select the security zone
containing the private IP address that you entered in the previous step.
6. Click Apply. The policy that you created is now listed on the Configure
Policies for Security Zone window.