Quick Start - HP 7102dl - ProCurve Secure Router Configuration Manual

IP Routing—Configuring RIP, OSPF, BGP, and PBR

Quick Start

15-178
Quick Start
This section provides the commands you must enter to quickly configure:
RIP
OSPF:
• internal router
• ABR
• ASBR
BGP
You can use more than one routing protocol. When the router learns identical
routes through different routing protocols, it uses the administrative distances
shown in Table 15-28 to choose between them.
This section also includes the commands for configuring a route map for PBR.
Because the configuration of PBR is, by definition, dependent on your orga-
nization's policies, the quick-start commands are quite general.
Only a minimal explanation is provided. If you need additional information
about any of these options, check "Contents" on page 15-1 to locate the section
that contains the explanation you need.
Table 15-28. Hierarchy of Routes (Most Trusted to Least Trusted)
Route Type Default Administrative Distance
directly connected 0
static 1
BGP • 20 for external routes
• 200 for internal and local routes
OSPF 110
RIP v1 and v2 120