HP 7102dl - ProCurve Secure Router Configuration Manual page 494

Network Monitoring
Quick Start
9-66
26. Create a second NAT statement:
• Specify the ACL that you configured for local traffic.
• Specify the backup WAN interface or an IP address valid for the
backup connection.
• Specify the ACP for traffic on the primary interface.
Syntax: nat source list <listname> [address <A.B.C.D> | interface <interface>]
overload policy <policyname>
27. Disable the RPF check on the ACPs applied to the WAN interfaces. Enter
this global configuration mode command:
Syntax: no ip policy-class <policyname> rpf-check
28. Make sure that the firewall is enabled. From the global configuration
mode context, enter:
Syntax: ip firewall
Finally, activate the probes:
29. Access a probe's configuration mode context.
Syntax: probe <name>
30. Activate the probe.
Syntax: no shutdown
31. Repeat to activate other probes.