HP 7102dl - ProCurve Secure Router Configuration Manual page 861

Table 15-16. IP Precedence Values
Value
0
1
2
3
4
5
6
7
If your network uses DiffServ, you can select traffic according to its per-hop
behavior (PHB) setting. In networks that support DiffServ, a PHB defines such
settings as the bandwidth allocated to traffic and the traffic dropped first when
congestion occurs.
You can select:
the default PHB
a class selector (CS) PHB
an assured forwarding (AF) PHB
the expedited forwarding (EF) PHB
You can also select traffic marked with any DSCP used in your network. (See
Chapter 8: Setting Up Quality of Service for more information on DiffServ
and PHBs.)
To select traffic that does not have a set DiffServ value, match the entry to the
default PHB:
Syntax: match ip dscp default
CS PHBs provide backwards compatibility with IP precedence values. To
select a CS PHB, enter this command:
Syntax: match ip dscp [cs1 | cs2 | cs3 | cs4 | cs5 | cs6 | cs7]
Table 15-17 displays the DSCP for the CS PHB.
IP Routing—Configuring RIP, OSPF, BGP, and PBR
Priority
routine
priority
immediate
flash
flash-override
critical
internet
network
Configuring Policy-Based Routing
15-135