HP 7102dl - ProCurve Secure Router Configuration Manual page 684

Configuring Multicast Support with PIM-SM
Configuring PIM-SM
13-44
You would need to make the same configurations on the WAN routers at Site
A and Site B. Figure 13-14 shows the running-config for the Router at Site A.
hostname "RouterA"
ip multicast-routing
interface loop 1
ip address 10.1.66.10
no shutdown
interface eth 0/1
ip address 10.1.65.1
ip pim sparse-mode
no shutdown
interface t1 1/1
tdm-group 1 timeslots 1-24 speed 64
no shutdown
interface fr 1 point-to-point
frame-relay lmi-type ansi
no shutdown
bind 1 t1 1/1 1 frame-relay 1
interface fr 1.100 point-to-point
frame-relay interface-dlci 100
ip address 10.1.64.2
ip pim sparse-mode
router ospf
network 10.1.64.0 0.0.0.3 area 1
network 10.1.65.0 0.0.0.255 area 1
network 10.1.66.0 0.0.0.255 area 1
area 1 stub
!
router pim-sparse
rp-address 10.1.63.1
!
Figure 13-14. Example 1: Router A running-config
If you want to configure a default route at the stub site instead of a routing
protocol, then you should enable IGMP proxy instead of PIM-SM. The running-
config would be as shown in Figure 13-15.
255.255.255.0
255.255.255.0
255.255.255.252