Overview
CLI Tools
1-18
To save a configuration as a file on internal flash, enter the following command
from the enable mode context:
ProCurve# copy <source file location> <source config-file> flash [<filename>]
Replace <source file location> with the location of the configuration file
you are saving. Replace <source config-file> with startup-config or run-
ning-config. You must enter a destination filename unless the filename will
be the same as that of the source. For example, if you need to save the startup-
config file from the compact flash card to internal flash, enter:
ProCurve# copy cflash startup-config flash startup-config
Saving the Current or Start-up Configuration to a TFTP Server. To
initiate an upload of a configuration file to an external TFTP server, enter one
of the following commands from the enable mode context:
ProCurve# copy [flash | cflash] tftp
ProCurve# copy [startup-config | running-config] tftp
For example, if you wanted to upload the startup-config on compact flash to
your TFTP server, you would enter:
ProCurve# copy cflash tftp
When prompted for the Address of remote host?, enter the IP address of
the TFTP server.
When prompted for the Source filename?, enter the name of the configura-
tion file (startup-config or running-config) you would like to upload.
When you are prompted for the Destination filename?, enter the filename
you'd like the uploaded configuration file to be named.
The copy command can be used for other file TFTP management tasks
such as:
loading a running-configuration file from the TFTP server—Enter copy
tftp running-config.
loading a startup-configuration from the TFTP server—Enter copy tftp
startup-config.