Authenticator State - D-Link DGS-3620-28PC-SI Product Manual

xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
Limitations Using the Guest VLAN
1. Ports supporting Guest VLANs cannot be GVRP enabled and vice versa.
2. A port cannot be a member of a Guest VLAN and a static VLAN simultaneously.
3. Once a client has been accepted into the target VLAN, it can no longer access the Guest VLAN.
Remember, to set an 802.1X guest VLAN, the user must first configure a normal VLAN, which can be enabled here
for guest VLAN status. Only one VLAN may be assigned as the 802.1X guest VLAN.
To view this window, click Security > 802.1X > Guest VLAN Settings as shown below:
The fields that can be configured are described below:
Parameter Description
Enter the pre-configured VLAN name to create as an 802.1X guest VLAN.
VLAN Name
Set the ports to be enabled for the 802.1X guest VLAN. Click the All button to select all the
Port
ports.
Click the Apply button to accept the changes made.
Click the Delete button to remove the specific entry based on the information entered.

Authenticator State

This window is used to display the authenticator state. This window appears when the Authentication State is
enabled in 802.1X Global Settings window.
To view this window, click Security > 802.1X > Authenticator State as shown below:
The fields that can be configured are described below:
Parameter Description
Select a unit you want to display.
Unit
Use the drop-down menu to select a port to display.
Port
Click the Find button to locate a specific entry based on the information entered.
Click the Refresh button to refresh the display table so that new entries will appear.
Figure 8-13 Guest VLAN Settings window
Figure 8-14 Authenticator State window
327