Table of Contents
Advertisement
xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Profile ID
Profile Name
Access ID
Mode
Action
Figure 7-65 Egress ACL Flow Meter Configuration window
Description
Enter the Profile ID for the flow meter.
Enter the Profile Name for the flow meter.
Enter the Access ID for the flow meter.
Rate – Specify the rate for single rate two color mode.
Rate – Specify the committed bandwidth in Kbps for the flow.
Burst Size – Specify the burst size for the single rate two color mode. The unit is in kilobyte.
Rate Exceeded – Specify the action for packets that exceed the committed rate in single
rate two color mode. The action can be specified as one of the following:
Drop Packet – Drop the packet immediately.
Remark DSCP – Mark the packet with a specified DSCP. The packet is set to drop for
packets with a high precedence.
trTCM – Specify the "two-rate three-color mode."
CIR – Specify the Committed information Rate. The unit is Kbps. CIR should always be
equal or less than PIR.
PIR – Specify the Peak information Rate. The unit is Kbps. PIR should always be equal to or
greater than CIR.
CBS – Specify the Committed Burst Size. The unit is in kilobyte.
PBS – Specify the Peak Burst Size. The unit is in kilobyte.
srTCM – Specify the "single-rate three-color mode".
CIR – Specify the Committed Information Rate. The unit is in kilobyte.
CBS – Specify the Committed Burst Size. The unit is in kilobyte.
EBS – Specify the Excess Burst Size. The unit is in kilobyte.
Conform – This field denotes the green packet flow. Green packet flows may have their
DSCP field rewritten to a value stated in this field. Users may also choose to count green
packets by using counter parameter.
Replace DSCP – Packets that are in the green flow may have their DSCP field rewritten
using this parameter and entering the DSCP value to replace.
318
Advertisement
Table of Contents
