Table of Contents
Advertisement
xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
Parameter
DHCP Server State
Ping Packets (0-10)
Ping Timeout (10-2000)
Click the Apply button to accept the changes made for each individual section.
DHCP Server Exclude Address Settings
The DHCP server assumes that all IP addresses in a DHCP pool subnet are available for assigning to DHCP
clients. You must use this page to specify the IP address that the DHCP server should not assign to clients. This
command can be used multiple times in order to define multiple groups of excluded addresses.
To view this window, click Network Application > DHCP > DHCP Server > DHCP Server Exclude Address
Settings as shown below:
The fields that can be configured are described below:
Parameter
Begin Address
End Address
Click the Add button to add a new entry based on the information entered.
Click the Delete All button to remove all the entries listed.
Click the Delete button to remove the specific entry.
DHCP Server Pool Settings
This window is used to add and delete the DHCP server pool.
To view this window, click Network Application > DHCP > DHCP Server > DHCP Server Pool Settings as
shown below:
Description
Click the radio buttons to enable or disable the DHCP Server State.
Enter the numbers of ping packet that the Switch will send out on the network
containing the IP address to be allotted. If the ping request is not returned, the IP
address is considered unique to the local network and then allotted to the
requesting client. 0 means there is no ping test. The default value is 2.
Enter the amount of time the DHCP server must waits before timing out a ping
packet. The default value is 100.
Figure 9-9 DHCP Server Exclude Address Settings Window
Description
Enter the starting IP Address.
Enter the ending IP Address.
395
Advertisement
Table of Contents
