Authenticator State; Authenticator Statistics - D-Link xstack DES-3810 series Reference Manual

®
xStack
Parameter
VLAN Name
Port
Click the Apply button to accept the changes made.
Click the Delete button to remove the specific entry based on the information entered.

Authenticator State

This window is used to display the authenticator state.
To view this window, click Security > 802.1X > Authenticator State as shown below:
The fields that can be configured are described below:
Parameter
Port
Click the Find button to locate a specific entry based on the information entered.
Click the Refresh button to refresh the display table so that new entries will appear.
NOTE: The user must first globally enable Authentication Mode in the Error! Reference source not found.
window before initializing ports. Information in this window cannot be viewed before enabling the
authentication mode for either Port-based or MAC-based.

Authenticator Statistics

This window is used to display the authenticator statistics information.
To view this window, click Security > 802.1X > Authenticator Statistics as shown below:
DES-3810 Series Layer 3 Managed Ethernet Switch Web UI Reference Guide
Description
Enter the pre-configured VLAN name to create as an 802.1X guest VLAN.
Set the ports to be enabled for the 802.1X guest VLAN. Click the All button to select all
the ports.
Figure 9-14 Authenticator State window
Description
Use the drop-down menu to select a port to display.
296