Route Redistribution Settings - D-Link DGS-3620-28PC-SI Product Manual

xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
ECMP OSPF State
Destination IP
Source IP
CRC Low
CRC High
TCP/UDP Port
Click the Apply button to accept the changes made for each individual section.

Route Redistribution Settings

This window is used to redistribute the routing information from other routing protocols to RIP, OSPF or BGP.
To view the following window, click L3 Features > Route Redistribution Settings, as shown below:
The fields that can be configured are described below:
Parameter
Destination Protocol
Source Protocol
Type
Figure 5-12 ECMP Algorithm Settings window
Description
Click the radio buttons to enable or disable the ECMP OSPF state.
Tick the check box so that the ECMP algorithm will include the destination IP.
Tick the check box so that the ECMP algorithm will include the lower 5 bits of the
source IP. This attribution is mutually exclusive with CRC Low and CRC High. If it is
set, CRC Low and CRC High will be excluded.
Tick the check box so that the ECMP algorithm will include the lower 5 bits of the
CRC. This attribution is mutually exclusive with Source IP and CRC High. If it is set,
Source IP and CRC High will be excluded.
Tick the check box so that the ECMP algorithm will include the upper 5 bits of the
CRC. This attribution is mutually exclusive with Source IP and CRC Low. If it is set,
Source IP and CRC Low will be excluded.
Tick the check box so that the ECMP algorithm will include the TCP or UDP port.
Figure 5-13 Route Redistribution Settings
Description
Use the drop-down menu to select the destination protocol.
Use the drop-down menu to select the source protocol.
When OSPF is select in the Source Protocol drop-down menu, this is able to
configure.
All - To redistribute both OSPF AS-internal and OSPF AS-external routes to RIP.
Internal - To redistribute only the OSPF AS-internal routes.
160