Table of Contents
Advertisement
xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Interface Name
Click the Find button to find the interface entered.
Click the View All button to view all the interfaces configured on this switch.
Click the Edit button to re-configure the selected entry.
After clicking the Edit button, the following window will appear.
The fields that can be configured are described below:
Parameter
Area ID
Priority (0-255)
Hello Interval (1-65535)
Dead Interval (1-65535)
Instance ID (0-255)
Metric (1-65535)
Figure 5-50 OSPFv3 Interface Settings window
Description
Enter the OSPFv3 IP interface name.
Figure 5-51 OSPFv3 Interface Settings - Edit window
Description
Enter a 32-bit number in the form of an IPv4 address that uniquely identifies the
OSPFv3 area in the OSPFv3 domain.
Enter the priority used in the election of the Designated Router (DR). It is a number
between 0 and 255. Its default value is 1.
Enter the interval time between the transmissions of OSPFv3 Hello packets, in
seconds. The Hello Interval and Dead Interval should be the same for all routers on
the same link. The default value is 10.
Enter the interval time between the receipts of Hello packets from a neighbor router
before the selected area declares that router down. The Dead Interval must be
evenly divisible by the Hello Interval.
Enter the instance ID of the interface. The default value is 0.
Enter the field that allows the entry of a number between 1 and 65535 that is the
representative of the OSPFv3 cost of reaching the selected OSPFv3 interface. The
default value is 10.
192
Advertisement
Table of Contents
