Ptp Peer To Peer Transparent Port Settings - D-Link DGS-3620-28PC-SI Product Manual

xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
Delay Request
Interval (0-5)
Pdelay Request
Interval (1-32)
Synchronization
Interval (1-2)
Click the Apply button to accept the changes made.

PTP Peer to Peer Transparent Port Settings

This window is used to configure the Pdelay Request Interval of the P2P transparent clock.
To view this window, click L2 Features > PTP > PTP Peer to Peer Transparent Port Settings, as shown below:
The fields that can be configured are described below:
Parameter
Unit
From Port / To Port
Pdelay Request
Interval (1-32)
Click the Apply button to accept the changes made.
delay time of an event message.
E2E - The port is configured to use the delay request-response mechanism.
P2P - The peer delay mechanism.
The default is E2E.
Enter the permitted mean time interval between successive delay request messages
which are sent by a slave to a specific port on the master. This mean time interval
value is determined and advertised by a master.
Enter the permitted mean time interval between successive pdelay_request
messages.
Enter the mean time interval between successive Sync messages. Referred to as
syncInterval. Tick the Half Second check box to have the 0.5 second of syncInterval.
Figure 4-122 PTP Peer to Peer Transparent Port Settings window
Description
Select a unit you want to configure.
Select the port range to use for this configuration.
Enter the permitted mean time interval between successive pdelay_request
messages.
150