D-Link DGS-3620-28PC-SI Product Manual page 493

xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
<ipaddr>, MAC: <macaddr>, Port: <[unitID:]portNum>)
Parameters description:
string: User name
ipaddr: IP address
macaddr: MAC address
unitID: The unit ID
portNum : The port number
Event description: This log will be triggered when the number of authorized
users reaches the maximum user limit on the whole device.
Log Message: JWAC enters stop learning state.
Event description: This log will be triggered when the number of authorized
users is below the maximum user limit on the whole device in a time interval
(5 min).
Log Message: JWAC recovered from stop learning state.
Event Description: Loop back is detected under port-based mode.
LBD
Log Message:
Port < [unitID:] portNum> LBD loop occurred. Port blocked.
Parameters Description:
portNum: The port number.
Event Description: Port recovered from LBD blocked state under port-based
mode.
Log Message:
Port < [unitID:] portNum>LBD port recovered. Loop detection restarted
Parameters Description:
portNum: The port number.
Event Description: Loop back is detected under VLAN-based mode.
Log Message:
Port < [unitID:] portNum> VID <vlanID> LBD loop occurred. Packet discard
begun
Parameters Description:
portNum: The port number.
vlanID: the VLAN ID number.
Event Description: Port recovered from LBD blocked state under VLAN-based
mode.
Log Message:
Port < [unitID:] portNum> VID <vlanID> LBD recovered. Loop detection
restarted
Parameters Description:
portNum: The port number.
vlanID: the VLAN ID number.
Event Description: The number of VLAN in which loop back occurs hit the
specified number.
Log Message:
Loop VLAN number overflow.
Parameters Description:
None
Event description: Dynamic IMPB entry conflicts with static ARP.
IMPB
Log Message: Dynamic IMPB entry conflicts with static ARP(IP: <ipaddr>,
MAC: <macaddr>, Port <[unitID:]portNum>)
Parameters description:
ipaddr: IP address
macaddr: MAC address
unitID: The unit ID
portNum : The port number
Event description: Dynamic IMPB entry conflicts with static FDB.
Log Message: Dynamic IMPB entry conflicts with static FDB(IP: [<ipaddr> |
<ipv6addr>], MAC: <macaddr>, Port <[unitID:]portNum>)
Parameters description:
ipaddr: IP address
ipv6addr: IPv6 address
macaddr: MAC address
unitID: The unit ID
portNum : The port number
Event description: Dynamic IMPB entry conflicts with static IMPB.
Log Message: Dynamic IMPB entry conflicts with static IMPB(IP: [<ipaddr> |
<ipv6addr>], MAC: <macaddr>, Port <[unitID:]portNum>).
Parameters description:
ipaddr: IP address
ipv6addr: IPv6 address
macaddr: MAC address
unitID: The unit ID
portNum : The port number
Event description: Creating IMPB entry failed due to no ACL rule being
available.
483
Warning
Warning
Critical
Informational
Critical
Informational
Informational
Warning
Warning
Warning
Warning