Table of Contents
Advertisement
xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
IP Address
Peer Group Name
EBGP Multihop (1-255)
Weight (0-65535)
Update Source Action
Interface Name
Send community
Next Hop Self
Soft Reconfiguration
Inbound
Remove Private AS
Allow AS in
Allow AS in Value (1-
10)
Default Originate State
Route Map Name
Click the Apply button to accept the changes made.
BGP Neighbor Timer Settings
This window is used to configure BGP neighbor timer settings.
To view the following window, click L3 Features > BGP > BGP Neighbor > BGP Neighbor Timer Settings, as
shown below:
Click the radio button and use the drop-down menu to select the IP address of the
BGP speaking neighbor.
Click the radio button and use the drop-down menu to select the name of the BGP
peer group.
Enter the TTL of the BGP packet sent to the neighbor.
Enter a value for weight. The valid range is from 0 to 65535. If this is not specified,
the routes learned through another BGP peer will have a default weight of 0. Routes
sourced by the local router have a weight of 32768. It cannot be changed. Tick the
Default check box to use the default weight value.
Enter an interface to be used by BGP sessions for TCP connection. By default, this
parameter is not set.
Enter the IP interface name used.
Use the drop-down menu to select Standard or None. This specifies the communities
attribute to be sent to the BGP neighbor. Standard means only standard communities
will be sent and None means no communities will be sent. The default value is
Standard.
Enable or disable the next hop self attribute. By default, this setting is Disabled
Enable or disable the inbound soft reconfiguration function. By default, this setting is
Disabled.
If this setting is set to Enabled, the private AS number in the AS path attribute of the
BGP update packets will be dropped. By default, the setting is Disabled.
If this is Enabled, the BGP router's self AS is allowed in the AS path list. By default,
this setting is Disabled. If no number is supplied, the default value of three times is
used.
Enter an Allow AS in Value between 1 and 10.
Enable or disable the default originate function. By default, this setting is Disabled.
Enter a Route Map Name of a maximum of 16 characters.
Figure 5-125 BGP Neighbor Timer Settings window
241
Advertisement
Table of Contents
