D-Link DGS-3620-28PC-SI Product Manual page 228

xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
This window is used to display list all the RP-Set information.
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv4 > PIM
RP-Set Table, as shown below:
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
PIM SSM Settings
This window is used to enable the SSM (Source-Specific Multicast) service model in PIM-SM on the Switch. The
PIM-SSM function will take active only when SSM service model and PIM-SM state both enabled.
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv4 > PIM
SSM Settings, as shown below:
The fields that can be configured are described below:
Parameter
SSM Service Model
State
SSM Group Address
SSM Group Mask
Click the Apply button to accept the changes made.
PIM for IPv6 (EI Mode Only)
PIM for IPv6 Global Settings
This window is used to set the PIM for IPv6 multicast protocol state and some related parameters in the protocol on
some interfaces.
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv6 > PIM for
IPv6 Global Settings, as shown below:
Figure 5-90 PIM RP-Set Table window
Figure 5-91 PIM SSM Settings window
Description
Click the radio buttons to enable or disable the SSM service model on the Switch.
Enter the group address range for the SSM service in IPv4. Tick the Default check box
to indicate that the group address range is 232.0.0.0/8.
Enter the netmask of the SSM group.
218