Table of Contents
Advertisement
xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
IP Address
Peer Group Name
Advertisement Interval
(0-600)
Keepalive (0-65535)
Hold Time (0-65535)
AS Origination Interval
(1-600)
Connect Retry Interval
(1-65535)
Click the Apply button to accept the changes made.
BGP Neighbor Map Settings
This window is used to configure BGP neighbor map settings.
To view the following window, click L3 Features > BGP > BGP Neighbor > BGP Neighbor Map Settings, as
shown below:
The fields that can be configured are described below:
Parameter
IP Address
Description
Click the radio button and use the drop-down menu to select the IP address of the
BGP speaking neighbor.
Click the radio button and use the drop-down menu to select the name of the BGP
peer group.
Enter the interval at which the BGP process sends update messages to its peer. The
valid value is from 0 to 600. If this value is set to zero, the update or withdrawn
message will be sent immediately. The default value for IBGP peers is 5 seconds and
for EBGP peers it is 30 seconds. When the Default check box is ticked, the neighbor
specific advertisement interval setting will be returned to the default setting.
Enter the interval at which a keepalive message is sent to its peers. If the two routers,
that build a BGP connection, have different keepalive timers, the smaller keepalive
timer will be unset. The valid value is from 0 to 65535. If the keepalive is set to zero,
then the keepalive message will not be sent out. Tick the Default check box to clear
the specification of the neighbor specific keepalive setting.
The system will declare a peer as dead if not receiving a keepalive message until the
hold time. If two routers, that built a BGP connection, have different hold times, the
smaller hold time will be used. The valid value is from 0 to 65535. If the holdtime is
zero, then the holdtime will never expire. It is recommended that the holdtime value is
three times that of the keepalive timer. Tick the Default check box to clear the
specification of the neighbor specific hold time setting.
Enter the minimum interval between the sending AS origination routing updates. The
valid value is from 1 to 600. The default setting is 15 seconds.
Enter the minimum interval BGP sends TCP connect requests to the peer after a
TCP connection fail happens. The valid value is from 1 to 65535. Tick the Default
check box to use the connect retry interval default value.
Figure 5-126 BGP Neighbor Map Settings window
Description
Click the radio button and use the drop-down menu to select the IP address of the
BGP speaking neighbor.
242
Advertisement
Table of Contents
