Table of Contents
Advertisement
xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
PDU Priority
Fault Alarm
Alarm Time
Alarm Reset Time
Click the Apply button to accept the changes made.
Click the <<Back button to discard the changes made and return to the previous page.
Click the Edit AIS button to configure the AIS settings.
Click the Edit LCK button to configure the LCK settings.
After clicking the Edit AIS button, the following window will appear:
The fields that can be configured are described below:
Parameter
State
Period
Level
Click the Apply button to accept the changes made.
Click the <<Back button to discard the changes made and return to the previous page.
After click the Edit LCK button, the following window will appear:
The 802.1p priority is set in the CCMs and the LTMs messages transmitted by the
MEP. The default value is 7.
This is the control types of the fault alarms sent by the MEP.
All - All types of fault alarms will be sent.
MAC Status - Only the fault alarms whose priority is equal to or higher than "Some
Remote MEP MAC Status Error" are sent.
Remote CCM - Only the fault alarms whose priority is equal to or higher than "Some
Remote MEP Down" are sent.
Errors CCM - Only the fault alarms whose priority is equal to or higher than "Error CCM
Received" are sent.
Xcon CCM - Only the fault alarms whose priority is equal to or higher than "Cross-
connect CCM Received" are sent.
None - No fault alarm is sent. This is the default value.
This is the time that a defect must exceed before the fault alarm can be sent. The unit
is in centiseconds, the range is 250-1000. The default value is 250.
This is the dormant duration time before a defect is triggered before the fault can be re-
alarmed. The unit is in centiseconds, the range is 250-1000. The default value is 1000.
Figure 10-8 CFM Extension AIS (Edit) Window
Description
Tick the check box and use the drop-down menu to enable or disable the AIS function.
Tick the check box and use the drop-down menu to select the transmitting interval of
AIS PDU.
Tick the check box and use the drop-down menu to select the client level ID to which
the MEP sends AIS PDU. The default client MD level is MD level at which the most
immediate client layer MIPs and MEPs exist. Options to choose from are values
between 0 and 7.
417
Advertisement
Table of Contents
