Table of Contents
Advertisement
xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
Click the Apply button to accept the changes made for each individual section.
LLDP Port Settings
On this page the user can configure the LLDP port parameters.
To view the following window, click L2 Features > LLDP > LLDP> LLDP Port Settings, as show below:
The fields that can be configured are described below:
Parameter
Unit
From Port / To Port
Notification
Admin Status
Subtype
from an LLDP neighbor. To set the LLDP Notification Interval, enter a value between 5
and 3600 seconds.
Figure 4-101 LLDP Port Settings window
Description
Select a unit you want to configure.
Use the drop-down menu to select the starting and ending ports to use.
Use the drop-down menu to enable or disable the status of the LLDP notification. This
function controls the SNMP trap however it cannot implement traps on SNMP when the
notification is disabled.
This function controls the local LLDP agent and allows it to send and receive LLDP
frames on the ports. This option contains TX, RX, TX And RX or Disabled.
TX - the local LLDP agent can only transmit LLDP frames.
RX - the local LLDP agent can only receive LLDP frames.
TX And RX - the local LLDP agent can both transmit and receive LLDP frames.
Disabled - the local LLDP agent can neither transmit nor receive LLDP frames.
The default value is TX And RX.
Use the drop-down menu to select the type of the IP address information will be sent.
136
Advertisement
Table of Contents
