Connecting An Srx210 Services Gateway To The Cli Locally - Juniper SRX210 Series Manual

SRX210 Services Gateway Hardware
Related
Documentation

Connecting an SRX210 Services Gateway to the CLI Locally

118
To enable communication between the management device and the services gateway,
ports 0/1 through 0/7 are preconfigured with the IP address
assign an IP address in the
To connect to the Ethernet port:
Ensure that the IP address for the Ethernet port on the management device is
1.
configured in one of the following ways:
The IP address is assigned by DHCP.
The IP address is in the
Turn off the management device.
2.
Plug one end of the CAT-5e (Ethernet cable) into the Ethernet port on the management
3.
device.
Connect the other end of the Ethernet cable to any of the built-in Ethernet ports 0/1
4.
through 0/7 on the services gateway.
If the services gateway has not already been powered on, power it on now.
Wait until the Status LED on the front panel of the services gateway turns steady
5.
green.
Turn on the power to the management device. The services gateway assigns an IP
6.
address to the management device within the
management device is configured to use DHCP.
To access the setup wizard, open a Web browser on the management device and
7.
enter the IP address
192.168.1.1
Performing Initial Software Configuration on the SRX210 Services Gateway Using the
Setup Wizard
Connecting an SRX210 Services Gateway to the CLI Locally on page 118
SRX210 Services Gateway Software Configuration Overview on page 125
SRX210 Services Gateway Secure Web Access Overview on page 137
If you plan to use the CLI to configure the SRX210 Services Gateway, you must connect
through the console port, as shown in
network to any connected device.
192.168.1.0/24
192.168.1.0/24 subnetwork (but is not
192.168.1.0/24
in the address field.
Figure 27 on page
and use DHCP to
192.168.1.1
192.168.1.1 ).
subnetwork if the
119.
Copyright © 2012, Juniper Networks, Inc.