Fire Safety Requirements For M Series, Mx Series, And T Series Routers; General Fire Safety Requirements; Fire Suppression; Figure 94: Placing A Component Into An Electrostatic Bag - Juniper Networks Hardware Manual

Related
Documentation

Fire Safety Requirements for M Series, MX Series, and T Series Routers

General Fire Safety Requirements

Fire Suppression

Copyright © 2010, Juniper Networks, Inc.
All manuals and user guides at all-guides.com
Appendix A: Safety and Regulatory Compliance Information for the M120 Router
on page 193). If you are returning a component, place it in an electrostatic bag before
packing it.

Figure 94: Placing a Component into an Electrostatic Bag

Definition of Safety Warning Levels on page 187
General Safety Warnings for M Series, MX Series, and T Series Routers on page 190
AC Power Electrical Safety Guidelines for the M120 Router on page 213
DC Power Electrical Safety Guidelines for the M120 on page 217
General Fire Safety Requirements on page 193
Fire Suppression on page 193
Fire Suppression Equipment on page 194
In the event of a fire emergency involving routers and other network equipment, the safety
of people is the primary concern. Establish procedures for protecting people in the event
of a fire emergency, provide safety training, and properly provision fire-control equipment
and fire extinguishers.
In addition, establish procedures to protect your equipment in the event of a fire
emergency. Juniper Networks products should be installed in an environment suitable
for electronic equipment. We recommend that fire suppression equipment be available
in the event of a fire in the vicinity of the equipment, and that all local fire, safety, and
electrical codes and ordinances be observed when installing and operating your
equipment.
In the event of an electrical hazard or an electrical fire, first turn power off to the equipment
at the source. Then use a Type C fire extinguisher, which uses noncorrosive fire retardants,
193