Fire Safety Requirements For M Series, Mx Series, And T Series Routers; General Fire Safety Requirements; Fire Suppression; Figure 58: Placing A Component Into An Electrostatic Bag - Juniper M7I Hardware Manual

Related
Documentation

Fire Safety Requirements for M Series, MX Series, and T Series Routers

Copyright © 2010, Juniper Networks, Inc.
Appendix A: Safety and Regulatory Compliance Information for the M7i Router

Figure 58: Placing a Component into an Electrostatic Bag

Definition of Safety Warning Levels on page 123
General Safety Warnings for M Series, MX Series, and T Series Routers on page 126
M7i AC Power Electrical Safety Guidelines and Warnings on page 149
M7i DC Power Electrical Safety Guidelines on page 149
General Fire Safety Requirements on page 129
Fire Suppression on page 129
Fire Suppression Equipment on page 130

General Fire Safety Requirements

In the event of a fire emergency involving routers and other network equipment, the safety
of people is the primary concern. Establish procedures for protecting people in the event
of a fire emergency, provide safety training, and properly provision fire-control equipment
and fire extinguishers.
In addition, establish procedures to protect your equipment in the event of a fire
emergency. Juniper Networks products should be installed in an environment suitable
for electronic equipment. We recommend that fire suppression equipment be available
in the event of a fire in the vicinity of the equipment, and that all local fire, safety, and
electrical codes and ordinances be observed when installing and operating your
equipment.

Fire Suppression

In the event of an electrical hazard or an electrical fire, first turn power off to the equipment
at the source. Then use a Type C fire extinguisher, which uses noncorrosive fire retardants,
to extinguish the fire. For more information about fire extinguishers, see "Fire Suppression
Equipment" on page 130.
129