Radius Server Key; Radius Server Msgauth - NETGEAR FSM7328PS - ProSafe 24 Port 10/100 L3 Managed Stackable Switch Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
11.2.2.1 no radius server host
This command is used to remove the configured RADIUS authentication server or the
RADIUS accounting server. If the 'auth' token is used, the previously configured RADIUS
authentication server is removed from the configuration. Similarly, if the 'acct' token is
used, the previously configured RADIUS accounting server is removed from the
configuration. The
configured RADIUS authentication / accounting server.
Format
Mode

11.2.3 radius server key

This command is used to configure the shared secret between the RADIUS client and the
RADIUS accounting / authentication server. Depending on whether the 'auth' or 'acct'
token is used, the shared secret is configured for the RADIUS authentication or RADIUS
accounting server. The IP address provided must match a previously configured server.
When this command is executed, the secret is prompted.
Note: The secret must be an alphanumeric value not exceeding 16 characters.
Format
Mode

11.2.4 radius server msgauth

This command enables the message authenticator attribute for a specified server.
Format
Mode
11.2.4.1 no radius server msgauth
This command disables the message authenticator attribute for a specified server.
Format
Mode
11-16
parameter must match the IP address of the previously
<ipaddr>
no radius server host {auth | acct} <ipaddress>
Global Config
radius server key {auth | acct} <ipaddr>
Global Config
radius server msgauth <ipaddr>
Global Config
no radius server msgauth <ipaddr>
Global Config
Port-Based Access and Authentication Commands
v3.0, January 2008