Show Ip Interface - NETGEAR FSM7328PS - ProSafe 24 Port 10/100 L3 Managed Stackable Switch Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

14.2.17 show ip interface

This command displays all pertinent information about the IP interface.
Format
Modes
Primary IP
Address
Secondary IP
Address
Routing Mode
Administrative
Mode
Forward Net
Directed
Broadcasts
Proxy ARP
Active State
Link Speed Data
Rate
MAC Address
Routing Commands
show ip interface <unit/slot/port>
Privileged EXEC
User EXEC
Displays the primary IP address and subnet masks for the
interface. This value appears only if you configure it.
Displays one or more secondary IP addresses and subnet
masks for the interface. This value appears only if you con-
figure it.
Is the administrative mode of router interface participation.
The possible values are enable or disable. This value was
configured into the unit.
Is the administrative mode of the specified interface. The
possible values of this field are enable or disable. This value
was configured into the unit.
Displays whether forwarding of network-directed broadcasts
is enabled or disabled. This value was configured into the
unit.
Displays whether Proxy ARP is enabled or disabled on the
system.
Displays whether the interface is active or inactive. An inter-
face is considered active if its link is up and it is in forward-
ing state.
Is an integer representing the physical link data rate of the
specified interface. This is measured in Megabits per second
(Mbps).
Is the burned in physical address of the specified interface.
The format is 6 two-digit hexadecimal numbers that are sepa-
rated by colons.
v3.0, January 2008
14-15