Client-Name; Default-Router - NETGEAR FSM7328PS - ProSafe 24 Port 10/100 L3 Managed Stackable Switch Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
7.1.2.1 no client-identifier
This command deletes the client identifier.
Format
Mode

7.1.3 client-name

This command specifies the name for a DHCP client. Name is a string consisting of
standard ASCII characters.
Default
Format
Mode
7.1.3.1 no client-name
This command removes the client name.
Format
Mode

7.1.4 default-router

This command specifies the default router list for a DHCP client. {
} are valid IP addresses, each made up of four decimal bytes ranging from 0 to
address8
255. IP address 0.0.0.0 is invalid.
Default
Format
Mode
7.1.4.1 no default-router
This command removes the default router list.
Format
Mode
DHCP Commands
no client-identifier
DHCP Pool Config
none
client-name <name>
DHCP Pool Config
no client-name
DHCP Pool Config
none
default-router <address1>
[<address2>....<address8>]
DHCP Pool Config
no default-router
DHCP Pool Config
v3.0, January 2008
address1, address2...
7-3