Power Over Ethernet (Poe) Commands - NETGEAR FSM7328PS - ProSafe 24 Port 10/100 L3 Managed Stackable Switch Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
Attached to the PSE is the UPS. A UPS is connected to each device that requires
alternative power. With Power over Ethernet, this function is centralized in a UPS
connected to the PSE. Note that this may require further changes in the environmental
conditions of the room needing to support this UPS with all of its electrical and cooling
requirements.
The current delivered to each node is limited to 350 milliamps. The total amount of
continuous power that can be delivered to each node, taking into account some power loss
over the cable run, is 12.95 watts. IP phones and wireless LAN access points typically
consume 3.5 to 10 watts. Power is carried on two wire pairs, to comply with safety
standards and existing cable limitations.
Management may also be added to monitor and control the PSE. This management
function may be integrated into a standard network management platform using the simple
network management protocol (SNMP) or through a custom platform. Beyond the basic
control of the PSE, the management stations provides additional power management
functions, like power quality of service (QoS) where key users are given higher priority to
power in the event of a outage.
Voice-over IP (VoIP), is the transmission of telephone calls over a data network like one of
the many networks that make up the Internet.
Other NETGEAR products that work with the 7300S Series Stackable Switch:
• WG302
• WG602
• WAG302

16.1 Power Over Ethernet (POE) Commands

This section shows the additional CLI commands required to provide the management
interface to the Power-over-Ethernet (PoE) function. The commands only applies to
FSM7328PS and FSM7352PS models.
Note: For the FSM7328PS, only ports 1-24 are eligible to participate in the PoE
16-2
function. For the FSM7352PS, only ports 1-48 are eligible to participate in
the PoE function.
v3.0, January 2008
Power Over Ethernet Commands