Dvlan-Tunnel Ethertype; Mode Dot1Q-Tunnel; Mode Dvlan-Tunnel - NETGEAR FSM7328PS - ProSafe 24 Port 10/100 L3 Managed Stackable Switch Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

6.3.2 dvlan-tunnel etherType

This command configures the ether-type for the specified interface. The ether-type may
have the values of
optional value of the custom ether type must be set to a value from 0 to 65535.
Default
Format
Mode
6.3.2.1 no dvlan-tunnel etherType
This command configures the ether-type for the specified interface to its default value.
Format
Mode

6.3.3 mode dot1q-tunnel

This command is used to enable Double VLAN Tunneling on the specified interface.
Default
Format
Mode
6.3.3.1 no mode dot1q-tunnel
This command is used to disable Double VLAN Tunneling on the specified interface. By
default, Double VLAN Tunneling is disabled.
Format
Mode

6.3.4 mode dvlan-tunnel

Use this command to enable Double VLAN Tunneling on the specified interface.
Note: When you use the
6-16
, , or
802.1Q vMAN custom
vman
dvlan-tunnel etherType <802.1Q | vman | custom>
[0-65535]
Interface Config
no dvlan-tunnel etherType
Interface Config
disabled
mode dot1q-tunnel
Interface Config
no mode dot1q-tunnel
Interface Config
mode dvlan-tunnel
becomes a service provider port. Ports that do not have double VLAN
tunneling enabled are customer ports.
v3.0, January 2008
. If the ether-type has a value of
command on an interface, it
, the
custom
VLAN Commands