Port-Based Traffic Control Commands; Port Security Commands - NETGEAR FSM7328PS - ProSafe 24 Port 10/100 L3 Managed Stackable Switch Reference Manual

This section describes the port-based traffic control commands available in the 7300S
Series Stackable Switch CLI.
This section includes the following topics:
• Section 9.1, "Port Security Commands"
• Section 9.2 "Storm Control Commands" on page 9-5
This section provides a detailed explanation of the security commands. The commands are
divided into the following groups:
• Configuration commands are used to configure features and options of the switch. For
every configuration command there is a show command that will display the
configuration setting.
• Show commands are used to display switch settings, statistics and other information.

9.1 Port Security Commands

This section describes the command you use to configure Port Security on the switch. Port
security, which is also known as port MAC locking, allows you to secure the network by
locking allowable MAC addresses on a given port. Packets with a matching source MAC
address are forwarded normally, and all other packets are discarded.
Note: To enable the SNMP trap specific to port security, see

Port-Based Traffic Control Commands

Port-Based Traffic Control Commands
"snmp-server traps violation" on page
v3.0, January 2008
Chapter 9
Section 10.1.8
10-4.
9-1