NETGEAR FSM7328PS - ProSafe 24 Port 10/100 L3 Managed Stackable Switch Reference Manual page 303

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
New LSAs
Originated
LSAs Received
External LSDB
Limit
Default Metric
Default Route
Advertise
Always
Metric
Metric Type
Maximum Paths
Redistributing
Source
Metric
Metric Type
Tag
Subnets
Distribute-List
Routing Commands
Shows the number of new link-state advertisements that have
been originated.
Shows the number of link-state advertisements received
determined to be new instantiations.
Shows the maximum number of non-default AS-external-
LSAs entries that can be stored in the link-state database.
Default value for redistributed routes.
Indicates whether the default routes received from other
source protocols are advertised or not
Shows whether default routes are always advertised.
Shows the metric for the advertised default routes. If the met-
ric is not configured, this field is blank.
Shows whether the routes are External Type 1 or External
Type 2.
Shows the maximum number of paths that OSPF can report
for a given destination.
This field is a heading and appears only if you configure the
system to take routes learned from a non-OSPF source and
advertise them to its peers.
Shows source protocol/routes that are being redistributed.
Possible values are static, connected, or RIP.
Shows the metric of the routes being redistributed.
Shows whether the routes are External Type 1 or External
Type 2.
Shows the decimal value attached to each external route.
For redistributing routes into OSPF, the scope of redistribu-
tion for the specified protocol.
Shows the access list used to filter redistributed routes.
v3.0, January 2008
14-49