Snmp-Server Traps Linkmode; Snmp-Server Traps Multiusers; Snmp-Server Traps Stpmode - NETGEAR FSM7328PS - ProSafe 24 Port 10/100 L3 Managed Stackable Switch Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

10.1.11 snmp-server traps linkmode

This command enables Link Up/Down traps for the entire switch. When enabled, link
traps are sent only if the Link Trap flag setting associated with the port is enabled.
10.1.18 "snmp trap link-status" on page 10-9
Default
Format
Mode
10.1.11.1 no snmp-server traps linkmode
This command disables Link Up/Down traps for the entire switch.
Format
Mode

10.1.12 snmp-server traps multiusers

This command enables Multiple User traps. When the traps are enabled, a Multiple User
Trap is sent when a user logs in to the terminal interface (EIA 232 or telnet) and there is an
existing terminal interface session.
Default
Format
Mode
10.1.12.1 no snmp-server traps multiusers
This command disables Multiple User traps.
Format
Mode

10.1.13 snmp-server traps stpmode

This command enables the sending of new root traps and topology change notification
traps.
Default
Format
Mode
10-6
enabled
snmp-server traps linkmode
Global Config
no snmp-server traps linkmode
Global Config
enabled
snmp-server traps multiusers
Global Config
no snmp-server traps multiusers
Global Config
enabled
snmp-server traps stpmode
Global Config
v3.0, January 2008
Section
SNMP Commands