Show Vlan Association Mac; Show Vlan Port - NETGEAR FSM7328PS - ProSafe 24 Port 10/100 L3 Managed Stackable Switch Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

6.2.3 show vlan association mac

This command displays the VLAN associated with a specific configured MAC address. If
no MAC address is specified, the VLAN associations of all the configured MAC
addresses are displayed.
Format
Modes
Mac Address
VLAN ID
Note: This command only applies to GSM7300S series models.

6.2.4 show vlan port

This command displays VLAN port information.
Format
Modes
Interface
Port VLAN ID
Acceptable Frame
Types
6-14
show vlan association mac [<macaddr>]
Privileged EXEC
User EXEC
A MAC address for which the switch has forwarding and or
filtering information. The format is 6 or 8 two-digit hexadec-
imal numbers that are separated by colons, for example
01:23:45:67:89:AB.
There is a VLAN Identifier (VID) associated with each
VLAN.
show vlan port {<unit/slot/port> | all}
Privileged EXEC
User EXEC
Valid slot and port number separated by forward slashes. It is
possible to set the parameters for all ports by using the selec-
tors on the top line.
The VLAN ID that this port will assign to untagged frames or
priority tagged frames received on this port. The value must
be for an existing VLAN. The factory default is 1.
Specifies the types of frames that may be received on this
port. The options are 'VLAN only' and 'Admit All'. When set
to 'VLAN only', untagged frames or priority tagged frames
received on this port are discarded. When set to 'Admit All',
untagged frames or priority tagged frames received on this
v3.0, January 2008
VLAN Commands